Alto-professional Trouper User Manual download pdf (Page 6)

Linking

Note: The loudspeaker system that is connected to your source device is the "master"; the

linked loudspeaker system is the "slave." The source device sends its signal to the master,

and the master relays the signal to the slave.

If you are using two Trouper loudspeaker systems:

1. Make sure no audio is playing from your Bluetooth device. If it is, pause/stop playback

and wait 5 seconds.

2. Press and release the Stereo Link button on each loudspeaker.

3. Both loudspeakers' LEDs will flash while "searching" for each other, and you will hear a

tone sequence from both loudspeakers. (This process may take up to 60 seconds.

However, the very first time you link the loudspeakers, the process may take up to 3

minutes.)

4. When they are successfully linked, you will hear a final "confirmation tone" from both

loudspeakers and the Stereo Link LEDs on both loudspeakers will light continuously.

Note: The stereo signal will be split between the two loudspeakers: the master loudspeaker

will play the left channel; the slave loudspeaker will play the right channel.

Tip: When using two loudspeakers, we recommend labeling the master loudspeaker so you

can distinguish between the two in future setups.

Additional Information

Trouper loudspeaker systems will remember their pairing and linking settings even after they

are powered off. When you turn the loudspeakers back on, they will automatically reconnect to

each other. When the connections are re-established between the loudspeakers, the LEDs

next to the Stereo Link buttons will light continuously.

Tip: Once your device is paired to the loudspeaker, the loudspeaker will remember the device

even after power-cycling it. To reconnect, go to your device's Bluetooth settings page and

select Connect to re-establish the connection.

If the connection is lost between the loudspeakers, or between the loudspeaker and the

source device, and if they do not reconnect automatically, power-cycle both loudspeakers and

allow them to reconnect.

When the two loudspeakers are linked, you can only pair your source device to the master

loudspeaker. The slave loudspeaker's Pair button will be disabled; if you press it, you will hear

3 rapid "beeps" to indicate that the button is "locked out."

To erase all previous pairing and linking settings, press and hold either the Pair button or

the Stereo Link button for 3 seconds. You will hear a long tone to confirm its pairing and

linking settings have been erased. The LEDs will also turn off. Do this on both the master and

the slave loudspeakers. Now, you can pair to a new source device or link the loudspeakers

again.

Note: The volume of the pairing and linking tones are pre-set to an optimal level.

1 2 3 4 5 6 7 8 9 10 11 ... 39 40

No comments

Alto-professional Trouper User Manual Page 6